How to Wire Wrap a Multi Gemstone Necklace
•
3 likes•3,280 views
Original wire work necklace design by Judy Larson. For more jewelry making tutorials and inspirations, check out www.beadinggem.com
Recommended
More Related Content
What's hot
What's hot (20)
Similar to How to Wire Wrap a Multi Gemstone Necklace
Similar to How to Wire Wrap a Multi Gemstone Necklace (20)
Recently uploaded
Recently uploaded (20)
How to Wire Wrap a Multi Gemstone Necklace
- 1. Multi Gemstone Neckpiece Judy Larson Chain: Two 4mm ID 18 gauge jump rings were used for each link Framework: Cut two 10” pieces of 16 gauge round wire (top will be cut shorter later) Wrap Wire: 16 feet of 26 gauge-7½’ for the top and 8½’ for the bottom Directions: Step 1: Using Step 2 on a 6 Step pliers, make a loop on one end of both the framework wire. Step 2: Shape the framework wires using the photo below. Step 3: Starting 7½ feet in from the end of the wrap wire, wrap both ends of the framework together just below the loops with 6-7 wraps. Step 4: Wrap outwards for about ½”, making sure to use the shorter wrap wire (the 7½’ length) on the upper framework wire. Use an Ultra Fine Point Sharpie Marker to mark the upper and lower wires where the first hole on the first bead will be. Wrap to that point. Step 5: Slide a bead on the top wrap wire and push up to the framework. Slide the bottom wrap wire through the bead. Pull both wrap wires tight, pulling the framework snugly up against the bead. Step 6: Repeat this process until all the beads are connected to the framework. Step 7: Finish the framework ends to mirror the beginning. Trim framework wires off to appx. 3/8” and make loops. Step 8: Attach the chain to fit your neckline (add 2” extender if desired) and then add the closure.