That is a very creative use of a clasp. I just bought one like yours the day before yesterday.
March 2, 2014 at 8:52 AM
Toggle clasps are often attractive. Why not make a pendant out of them with some simple and quick wire work? It will be a distinctive and unique design. Stylish too.
[Image]
You'll need 22 or 20G dead soft wire and a toggle clasp set. I used 20G. Cut about 10 inches of wire. Leave an upright tail about 4 inches on the left of the bar and hook up the loop of the main part of the clasp.
[Image]
Wrap the working end of the wire to the right of the bar's loop :
[Image]
Bring the working wire back to the front by poking it out of the lower loop, from the back:
[Image]
Guide the working wire towards the back to the left of the bar's loop, and then poke to the front again through the bottom loop.
[Image]
There are now two wraps on either side of the bar's loop :
[Image]
Now take the working wire and push it through the top loop from front to back :
[Image]
Straighten the two wire ends with a nylon jawed pliers:
[Image]
Grasp the wires with the large bail forming pliers (smaller jaw to the front). If you do not have this tool, a marker pen will also work.
[Image]
Bend the wires to the front and down :
[Image]
Take each wire end and poke them through the top loop while still keeping hold on the pliers :
[Image]
Gently pull the wires taut towards the back to regain their shape around the plier jaws.
[Image]
Bring the wires to the front and twist them together 1-2 times.
[Image]
Trim the wire ends to a suitable length for eg 1 or 1 1/2 inches, depending on how large you like the scrolled sections to be.
[Image]
Make a small loop at the end of each wire with a round nose pliers. Then scroll them using either the nylon jawed pliers or chain nose pliers. And you're done!
[Image]
[Image]
The toggle clasp and wire were courtesy of Prima Bead. Before You Go:
How to Wire Wrap Bails Tutorials
More Lovely Wire Clasp Tutorials to Try
How to Make a Bead and Wire Toggle and Bar Clasp
______________________________
Original Post by THE BEADING GEM Jewelry Making Tips - Jewelry Business Tips
posted by The Beading Gem at 8:00 AM on Feb 28, 2014
"How to Wire a Toggle Clasp as a Pendant"
6 Comments -
Nicely done. Will try it for sure.
February 28, 2014 at 8:08 AM
Thanks for the lovely detailed tute, Pearl! I just love your construction!
February 28, 2014 at 11:41 AM
Thanks! And happy constructing yourself!
February 28, 2014 at 11:44 AM
Ingenious! It makes for a very attractive pendant. Now I'm going to have to look through my stash of clasps to see what I have on hand. :)
February 28, 2014 at 5:44 PM
Bet you'll have a stack of pendants all ready for beaded necklaces in next to no time!
February 28, 2014 at 9:36 PM
That is a very creative use of a clasp. I just bought one like yours the day before yesterday.
March 2, 2014 at 8:52 AM